Reference for Avaya Communications DEFINITY G3

DEFINITY G3 switch configuration

Figure 4 shows the hardware configuration for the Ethernet link between the DEFINITY G3 and CallPath Server for Windows NT/Windows 2000.

Figure 4. Configuration for the CallPath Server for Windows NT/Windows 2000 connection to the DEFINITY G3

DEFINITY G3 switch hardware and software requirements

To use the DEFINITY G3 with CallPath Server for Windows NT/Windows 2000, the following minimum hardware and software are required:

Minimum hardware requirements

A DEFINITY G3 is required.

Additional hardware may be necessary in order to use all of the CallPath features.

Contact your DEFINITY G3 installation representative for installation, configuration, and required upgrades for your DEFINITY G3 hardware.

Minimum software requirements

DEFINITY G3 Adjunct/Switch Applications Interface (ASAI) CallVisor system software is required

Additional sotware options may be necessary to use all of the CallPath features. CallPath implements all of the ASAI functionality which may not be available with your particular switch.

Contact your DEFINITY G3 installation agent for installation, configuration, and required upgrades for your DEFINITY G3 software. When configuring the ASAI port, ensure the installation agent uses the following Feature Code options:

Event minimization?

Y

XID?

N

MIM support?

N

Fixed TEI?

Y for Ethernet (TEI Length=1 or 3)

Note:

If using more than one CallPath Servers to connect to this switch, ensure that all TEI lengths are the same; either all 1 or all 3. Mixing these values will lead to incomplete event flows.

CRV length:

2

CallPath Server for Windows NT/Windows 2000 hardware and software requirements

To use CallPath Server for Windows NT/Windows 2000 in a direct connection with the DEFINITY G3, the following hardware and software are required in addition to the base CallPath Server for Windows NT/Windows 2000 hardware and software requirements that are described in the CallPath Server Planning, Installation, and Problem Determination Guide.

Hardware requirements

Any 10BASE-T Ethernet card with an RJ45 connector and an appropriate connection cable is required to connect the IBM PC running CallPath Server for Windows NT/Windows 2000 to the DEFINITY G3.

Notes:

1. Use a separate Ethernet card for connectivity to the DEFINITY G3 to prevent performance problems and toll fraud. A single Ethernet card cannot be used for both host and DEFINITY G3 connectivity.

2. A 10BASE-T hub with RJ45 connectors is also required for connectivity to the DEFINITY G3.

Software requirements

• Ethernet software supplied with the Ethernet card
• Transmission Control Protocol/Internet Protocol (TCP/IP) software